The cutting machine mainly includes a cutting table, a tool holder, a tool holder, an operating panel and a vacuum suction device.

Folding and cutting table:

It will not collide with the countertop to prevent tool and countertop damage.

Folding knife holder:

It is set up on the cutting table and driven by the driving shaft on the edge of the table to move in the direction of the table x axis.

Folding knife holder:

It is installed on the tool holder and driven by the tool holder drive shaft to move in the y axis direction of the table surface, and the combination of the tool holder and the tool holder movement makes the tool complete various curves or straight lines of cutting.

Folding operation panel:

On this panel are the cutting speed, sharpening distance, tool holder, tool holder start or temporarily stop cutting and other work command keys. The operator only needs to follow the operation panel and press the corresponding command key at any time according to the actual situation.

Folding vacuum suction device:

The device is connected to the air inlet under the cutting table through the catheter, and after starting, the air can be extracted between the table and the other plastic film covered on the cloth, and the fabric is compressed by atmospheric pressure, so that it is tightly adsorbed on the cutting table, so that the fabric layer will not slide due to the movement of the cutting knife during cutting, so as to ensure the accuracy of the cutting piece.

Length and width of cutting bed:

The length and width of the cutting bed depend on the amplitude of the fabric and the needs of the production variety. The common table width is 1000~2400mm, and the table length is about 2000mm.